Submersible
Water supply
Irrigation
Clear water
Stainless steel
High efficiency
Compact
Horizontal installation
・Pump complies with the water supply law in Japan as wetted surface is made by stainless steel.
・Optimized hydraulic design saves energy consumption.
・Installation space is minimized and pump runs with low noise as the pump is submerged.
・Water contamination is prevented by use of a water-tight type motor.
・Pump permits to drain close to bottom of the pit as suction inlet designs lower portion.
・Pump is allowed to install at the underground pit due to light-weight. Optional horizontal installation model is available for below 65 mm discharge model.
| Liquid | Type | Clear water | |
| Temperature | 0 to 40℃ | ||
| Contained sand limit | Up to 50mg/L | ||
| Contained chlorine limit | Up to 200mg/L | ||
| Max. pump submergence | 10m | ||
| Construction | Impeller | Enclosed | |
| Materials | Casing | 304 Stainless Steel | |
| Impeller | 304 Stainless Steel, Bronze(100mm discharge) | ||
| Shaft | 431 Stainless Steel | ||
| 316 Stainless Steel (80mm dischaege) | |||
| 403 Stainless Steel (100mm descharge) | |||
| Motor | Type | Water filled submersible motor, 2 pole | |
| Canned type | |||
| Starting | D.O.L. starting : Up to 7.5kW | ||
| Star deita starting : 11kW and over | |||
| Construction | Shaft seal | Oil seal | |
| Shaft | Mono block type | ||
| Materials | Frame | 304 Stainless Steel | |
| Shaft | 431 Stainless Steel | ||
| Cable | 2PNCT | ||
| Flange | Special flange(below 65mm descharge), JIS 10K normal type | ||